Where to Find A Machine to Make Ice Cream Cones?

Where to find a machine to make ice cream cones? A professional manufacturer of ice cream cone to ensure that the quality of the machine is guaranteed, manufacturers also have warranty period, affordable prices. Our company is located in zhengzhou, henan province, where the geographical location is superior, convenient for customers to visit the site.

The base and top cover of this ice cream cone making machine form a whole with four pillars. The first two pillars serve as the guide posts. The base is the installation base of the mold, which also bears all the weight of the machine. The electric box is at the bottom of the frame, and the heavy hammer is placed behind the electric box. Mold: composed of upper mold, lower mold and operating frame. Electrical part: the electric control elements are arranged in a drawer under the frame, and the loose bolts can be pulled out as a whole. This machine is an integral part of the ice cream machine and is used to make containers for ice cream or other fatty food.

Working principle of ice cream cone making machine:

Mold cavity heating: wipe off the mold cavity dirt and close the mold. Preset are baking temperature on temperature controller, xinji on general will die is temporarily set at 220 ℃, under 200 ℃, and electricity to heat up, until you reach the set temperature (about 30-40 minutes). At this time, there may be a trace of odour and smoke from the mold, which is the residual rust oil, paint and heat insulation materials adhesives, such as the baking out, the new machine is normal phenomenon, about 1-2 hours will be volatile clean, if long-term existence, or more and more concentrated, should be shut down for inspection.

Try baking: lift up the upper mold, push out the lower mold, wash and wipe off the rust prevention oil and dirt left in each mold cavity and core head, evenly spray the stripper oil (edible atomized silicon oil or refined fat-free oil), close the lower mold, add the paste to each mold cavity with the feeder, and cover the mold. Set time to 90 seconds for baking cycle. When the bell reports, can open the mold.